Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 26

For Fisher & Paykel Stainless steel door panels only.
IMPORTANT!
Remove protective film from white product
doors before hanging door panels.
Hang all door panels onto M8 studs and align
1
the side bracket forks onto the refrigerator
door (A).
– Ensure the forks are positioned around
the body of the side screws (M5x10 pan
head Phillips screw).
Push the product until the door panels
2
are flush.
– Depending on your installation design
this will be flush with your adjacent
cabinetry or your framework.
Place a ruler on the front of the product to
3
check flushness top and bottom, left and
right (B).
Ensure the gap between the top of the door
4
panel and the top cabinetry is no greater
than 7mm.
– To reduce this gap, raise the product
by turning all four adjustment nuts the
same number of turns.
IMPORTANT!
Failure to follow these steps can lead to
difficulties in door panel adjustment and
cosmetic cap fitment.
Lock top inner panel side screws
5
to allow opening the doors
without affecting adjustment.
(Open the left door to lock the
right screws and vice versa (C).)
C
24
!9 HANG NON-WATER DISPENSING DOOR PANELS
A
Place a ruler on the front of the
product to check flushness top
and bottom, left and right.
B
D
E
All door panels have Once satisfied with all
6 7
full axis adjustment to door panels, secure
ensure they are flush with M8 studs with M8 washer
adjacent walls. To adjust and M8 nut (E). The top
the height of each panel of the stud must remain
turn clockwise to raise below the top face of the
stud or counter-clockwise door panel.
to lower stud (D).
F
Secure side bracket forks
8
by tightening side screws (F).
Repeat this process for all door panels.
Note:
For depth adjustment loosen side screws (4x),
● ●
adjust panels and then retighten once satisfied.
Further adjustment of door panels can be achieved
● ●
by removing door panels then loosening the fixing
screws for the hanging bracket and moving the
bracket sideways to suit.
Loosely install locking bracket (G) into the pocket on the underside of the door using
9
a M8 stud. Slide the locking bracket out until it touches the back of the door panel.
Screw in place using a #8x16 screw through one of the three slotted holes.
Fully tighten the M8 stud.
G