Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 24

The assembly of Fisher & Paykel (Stainless steel) door panels and custom door panels are outlined below. To protect the finish of the Fisher & Paykel Stainless
steel door panels, leave protective film on the panels when hanging and remove film only when installation is complete.
If using custom door panels, ensure they are prepared as per 'Custom door panel installation dimensions' section.
Top door panels
Mounting handle (A)
1
For Fisher & Paykel door panel sets, remove
the plastic plugs from the handle holes (4x).
Align the handle to the holes and secure with
M5x25 pan head socket screws (4x).
For custom panels, ensure the handle is
secured 65mm from the inner edge of the
panel to the center. This will avoid interference
with the bracket installation.
Hanging bracket (B)
2
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with M5x14
mush Phillips SS screws (4x).
For custom panels, secure bracket with #8 x 16
mush washer screws (4x).
Side brackets and straps (C)
3
For Fisher & Paykel door panel sets, align the
side brackets and side straps to the holes on
the side of the panel and secure with M5x14
mush Phillips SS screws (2x).
For custom panels, secure the brackets with
#8x16 mush washer screws screws (2x).
C
22
!7 ASSEMBLE DOOR PANEL SET
Drawer door panel
Mounting handle (D)
4
For Fisher & Paykel door panel sets, remove
B
the plastic plugs from the handle holes (4x).
Align the handle to the holes and secure with
M5x25 pan head socket screws (4x).
For custom panels, ensure handle screw heads
are counter sunk into the back of the panel to
avoid interference with hanging bracket.
Hanging bracket (E)
5
A
For Fisher & Paykel door panel sets, align the
bracket to the holes and secure with M5x14
mush Phillips SS screws (6x).
For custom panels, secure bracket with #8x16
mush washer screws (6x).
Side brackets and straps (F)
6
For Fisher & Paykel door panel sets, align the
brackets and straps to the holes on the side of
the panel and secure with M5x14 mush Phillips SS
screws (2x).
For custom panels, secure brackets with #8x16
mush washer screws (2x).
D
E
F