Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 29

If applicable, remove any remaining protective
1
film on your door panels.
A
Open the refrigerator door, firmly push top
2
cover (A) over the top studs.
Door side trims
3
Install the side trims by inserting into the
panel gaps on each side of the door(s) (B).
@2 ATTACH COVERS AND DOOR/DRAWER TRIMS
B
C
Align the trim to the top of the door
and press evenly into the panel gap
until fully seated (C).
D
Press the 3M Dual Lock™ tabs together to
4
form pairs (D) and remove the adhesive
backing on one side only.
Drawer side trims
5
Install the side trims in the same manner (refer to step
Drawer top trim
6
Remove the remaining adhesive backing from the 3M Dual Lock™ tabs.
Locate the trim against the back surface of the panel and press down
firmly. Ensure the trim is fully seated against the drawer surface.
E
Press firmly to install on the underside
of the drawer top trim in the indicated
locations (E).
).
3
27