Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 25

For Fisher & Paykel Stainless steel door panels only.
Remove the external display
1
module from inside the product.
Thread the display harness
through the door panel cavity.
Ensure the grommet is engaged.
Remove water tube from holder on
3
the refrigerator door.
Hang door panel onto M8 studs.
4
Ensure the panel is free to pivot for
water connections (A).
!8 HANG WATER DISPENSING DOOR PANEL
Angle top display tabs into the
2
door panel. Ensure the harness
is free of pinching. Firmly push
against bottom display tabs
and insert into the door panel
until you feel it clip securely.
Ensure the display is flush with
the door panel.
A
A
B
Connect display harness onto the refrigerator door
5
by inserting firmly until you feel it clip securely (B).
On the external display, enable the dispenser lock,
this will help prevent any water from dispensing
during water connection. To lock, press the
button for 4 seconds. The LED above the button
will illuminate.
Firmly push the water tube into the spigot behind
6
the door panel until the marked line is not visible.
Ensure the water tube is routed away from any
sharp objects, sharp corners, and not in a location
where it can be kinked or squashed when the door
panel is secured, (as this will stop water flow).
To secure door panel, follow the instructions in
the next section: 'Hang non-Water dispensing
door panels'.
23