Fisher & Paykel ACTIVESMART RS9120W Installation Manual page 30

For custom toe kick greater than 102mm
Cut un-required vanes from the bottom of the grille
Measure the required height for the bottom grille. On a board, carefully score/cut
1
the un-required vanes from the bottom of the toe kick grille and discard (A).
Drill Ø 4mm holes into the dimples of the grille (B).
2
Repeat this process for all dimples.
Grille tabs
With the grille tabs facing upwards, align the grille to the
3
bottom of the plinth where the screw holes are located
and secure with #8x5/8" pan head screws (3x) (C).
DETAIL D
Align the air flow divider underneath the grille tabs
4
SCALE 2 : 1
indicator and clip onto the vanes of the bottom grille (D).
28
@3 ATTACH BOTTOM TOE KICK
B
A
C
Front right view
DETAIL B
SCALE 2 : 5
DETAIL A
SCALE 1 : 1
For toe kick installation at 102mm
DETAIL A
SCALE 1 : 1
1.
2.
With the grille tabs facing upwards, align the grille clips to the bottom
1
3.
of the plinth's slots, then firmly push grille onto the plinth (A).
Align the air flow divider underneath the grille tabs indicator
2
and clip onto the vanes of the bottom grille (B).
D
A
Grille tabs
DETAIL A
SCALE 1 : 1
IF TOEKICK IS HIGHER THAN 4" USE SIDE CUTTER TO
CUT UNREQUIRED VANES FROM DOTTOM
DRILL HOLES THROUGH DIMPLES
USE PROVIDED SCREWS TO FIX GRILL TO
MATCHING HOLES ON PLASTIC PARTS
DETAIL D
SCALE 2 : 1
B
DETAIL D
SCALE 2 : 1