CONTENTS SAFETY AND WARNINGS DUAL INSTALLATION COMPONENTS CAVITY DIMENSIONS ATTACH BRACKET ASSEMBLY TO CAVITY ATTACH FOAM PADS REMOVE HINGE BRACKET ATTACH CAVITY BRACKET POSITION INTO THE CABINETRY ATTACH CENTRE TRIM INSTALL TOE KICK...
SAFETY AND WARNINGS DUAL INSTALLATION Dual installation refers to the joining of one left hinge and one right hinge model using a WARNING! joiner kit (sold separately). Use RS91W joiner kit to pair 1 x RS91WR model with 1 x RS91WL model. ●...
COMPONENTS Dual install joiner kit Not supplied and must be purchased separately Joiner bracket Cavity fixing bracket Right hinge cavity bracket Left hinge cavity bracket Foam pads Centre trim Toe kick Bottom joiner bracket M8 nut Spring clips M8 Nut M8 Screw Set M8 set screw M5x12 Socket head cap screw...
CAVITY DIMENSIONS RS36W80 / RS9120W CAVITY DIMENSIONS Overall height of cavity for appliance using RD3680/RD9120 door panel set 84” 2134 for appliance using RD3684/RD9121 door panel set 80” 2032 Overall width of cavity 72” 1829...
ATTACH BRACKET ASSEMBLY TO CAVITY IMPORTANT! Ensure the anti tip brackets are installed before attaching the cavity fixing bracket. Refer to separate ‘Installation guide’ supplied with your appliance. ● ● Ensure the water and power supply are already connected, and door panels installed before attaching the cavity fixing bracket. ●...
ATTACH FOAM PADS Attaching foam pads to appliance Mark three locations along the edge of the non-hinge side of each appliance. Refer to the measurements table below. MEASUREMENTS Distance of first tab location from cabinet top 2” Distance of second tab location from cabinet top 35”...
REMOVE HINGE BRACKET IMPORTANT! Follow these steps to remove the hinge bracket on the non-hinge side of both left and 2 At the non-hinge side of the appliance, loosen the M5x10 pan head attachment screws from right hinge appliances. the end of the top trim, and then shift the screws towards the centre of the trim. (A) Removing hinge brackets from appliance 1 Measure the distance between the end of the top trim and the side of the cabinet.
ATTACH CAVITY BRACKET IMPORTANT! Follow these steps for fitting the cavity bracket on the non-hinge side of both left and right hinge appliances. Attaching cavity bracket to appliance 1 Screw the cavity bracket with two M5x8 countersunk Phillips screws (A) to the location where the hinge bracket was removed.
POSITION INTO THE CABINETRY IMPORTANT! DO NOT install the appliance on a soft, uneven, or unlevelled floor to avoid twisting the Ensure that the top, bottom and sidge gaps are not greater than 1/16" (1.5mm) to achieve ● ● ● ● appliance and poor door sealing.
ATTACH CENTRE TRIM Preparing the centre trim Attaching the centre trim between appliances 1 Remove the M10x65 socket head 1 Open both appliance doors. Position cap screws from the base of the the centre trim in front of the gap appliances.
Page 14
INSTALL TOE KICK Installing the toe kick 1 Loosen the screws (A) of the toe kick bracket mid-way, and pull the bracket slightly outward (B). Do this step for both appliances. 2 Place toe kick over the brackets and position the outer brackets (C) until flush with surrounding cabinetry.
Need help?
Do you have a question about the Activesmart RS36W80 and is the answer not in the manual?
Questions and answers