Wrong Code Entry – Lock Out; Low Battery Alert - Securam ProLogic L01 Operation Instructions Manual

ProLogic L01
2.2 Wrong Code Entry – Lock Out
If an invalid code is entered, the following message will be displayed:
If 4 invalid codes are entered consecutively, the safe lock will enter
The display will then report the length of time remaining in the Lock Out period every 15 seconds until it
has expired
After the 4 minute Lock out period, the following message will be displayed, you can now enter a valid
code to open the safe lock.
Enter a valid code to open the lock.
Note: If an invalid code is entered at this point, the lock will only accept 2 invalid entries before it goes
back into the 4 minute Lock out period.

2.3 Low Battery Alert

The display will alert a low battery condition when the battery voltage reaches 5.4±0.2V.
Operation Instructions
6