Connections; Ac Power (Mains) Cord Connection; Power Check; Switching On/Off - Barco R9000901 Owner's Manual

3

CONNECTIONS

AC Power (mains) Cord Connection

Use the supplied power cord to connect your projector to
the wall outlet. Plug the female power connector into the
male connector at the backside of the projector.

Power Check

Power voltage indication on sticker on the back side of the projector.
The power voltage is indicated by the art. no.
Warning !
Check if the indicated power voltage corresponds to that of the wall
outlet.
Art. No. R9000901 must be connected to a 230 VAC power source.
Art. No. R9000908 must be connected to a 120 VAC power source.
If the wall outlet voltage is different, call a qualified technician for
power adaptation of the projector.

Switching On/Off

The projector is switched ON and OFF using the power (mains) switch
ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image dis-
played) or in the 'stand by mode', depending on the position of the
'power up' dip switch on the controller unit. This DIP switch must be
set during installation by a qualified technician. If you want to change
this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector switched off
green color : projector in Operational mode
red color : projector is in Standby mode.
5975007 BARCOGRAPHICS 808S 051196
See installation instructions before connecting to the supply.
Voir la notice d'installation avant de raccorder au réseau.
120/230 V
7/5 Amp
50/60 Hz
PORT 4/5
RS232 IN RS232 OUT IR REMOTE
IN RS232 OUT RS232 IR REMOTE
green : operation
VIDEO OFF - ON
75 Ohm
red : standby
PORT 1 PROJECTOR MODE
Connections
Th is d evice co mp li es w it h part 15 of
th e FCC ru les. Op erati on i s su bj ect to
fo llo win g two co ndi tio ns (1). Th is
d evice may n ot cau se harmf ul i nt er-
f eren ce, an d ( 2) t hi s d evice mu st
accep t any in terf erence received
i nclu di ng i nt erferen ce t hat may cause
un desi red op erat io n"
75 Ohm 75 Ohm
PORT 2
120/230 V
7/5 Amp
50/60 Hz
This device complies with part 15 of
the FCC rules. Operation is subject to
following two conditions (1). This
device may not cause harmful inter-
ference, and (2) this device must
accept any interference received
including interference that may cause
undesired operation"
3-1