Table of Contents
Advertisement
NAS CLI Error Codes
NAS CLI Configuration Commands
Getting the Kernel Oplocks Setting
syscli --get smbsetting --oplocks | --dbglevel
This CLI command allows the CLI admin to display the kernel oplocks or the
debug level setting in CIFS.
Setting the Kernel Oplocks Setting
syscli --set smbsetting { --oplocks disabled|enabled } | { --dbglevel <n> }
This CLI command allows the CLI admin to change the kernel oplocks or debug
level setting in CIFS. In a bad network environment the kernel oplocks setting
should be disabled.
The following NAS CLI error codes can be generated:
E1000010 Failed to get CIFS server status!
E1000011 CIFS server is disabled!
E1000012 CIFS server is currently in workgroup!
E1000013 CIFS server is currently not in workgroup!
E1000014 CIFS server is required to be in workgroup!
E1000020 CIFS server is currently in Active Directory domain!
E1000021 CIFS server is currently not in Active Directory domain!
E1000022 CIFS server is required to be in Active Directory domain!
E1000030 Failed to get CIFS configuration!
E1000031 Failed to get CIFS domain setting!
E1000032 The domain type is invalid or not supported.
E1000035 User name for domain is missing.
E1000036 User name is missing domain name prefix.
E1000040 Failed to get NFS status!
E1000041 Failed to configure NFS!
E1000042 Failed to get NFS configuration!
E1000050 Workgroup user database (smb database) not found!
E1000051 Workgroup user not found in smb database (smbpasswd)!
E1000052 Workgroup user not found in local database (passwd)!
E1000053 Workgroup user does not exist!
E1000054 Workgroup user database corrupt (SMB and local datbases
mismatch)!
E1000055 Workgroup name is invalid!
E1000060 This command supports CIFS shares only!
E1000061 This command supports NFS shares only!
Quantum DXi-Series Command Line Interface (CLI) Guide
6-66538-03 Rev C
November 2010
53
Advertisement
Table of Contents
