Preparing For The Installation; Necessary Tools; Taking Esd Precautions; Unpacking The Dxi4000 - Quantum DXi4510 Installation And Configuration Manual

DXi4000 Installation and Configuration Guide

Preparing for the Installation

Necessary Tools

Taking ESD Precautions

Unpacking the DXi4000

4
Before you begin the installation procedure in this section, make the following
preparations as described in this section:
• Necessary Tools on page 4
• Taking ESD Precautions
Provide the following tools for unpacking and installing the DXi4000:
• #2 PHILLIPS screwdriver
• Notebook PC (for setting up initial system configuration)
Some components within the DXi4000 system contain static-sensitive parts. To avoid
damaging these parts while performing installation procedures, always observe the
following precautions:
• Keep the DXi4000 system turned off during all installation procedures.
• Keep static-sensitive parts in their original shipping containers until ready for
installation.
• Do not place static-sensitive parts on a metal surface. Place them inside their
protective shipping bag or on an antistatic mat.
• Avoid touching connectors and other components.
Note: Dry climates and cold-weather heating environments have lower relative
humidity and are more likely to produce static electricity.
By following these instructions, you help ensure that the system will continue to be
safeguarded after it arrives at the installation site.
Unpack and remove the following components from the packing materials (see
Figure 1):
• DXi4000 chassis
• Front bezel with key
• (4) power cords, (2) U.S. and (2) International
• (2) Ethernet cables
• Left and right slide assemblies
on page 4
Preparing for the Installation