Quantum DXi4510 Installation And Configuration Manual page 13

Figure 8 Power Buttons
The NMI button is recessed to prevent it
from being pressed accidently. Press only
when instructed by technical support
Power button
Front
Figure 9 Ethernet Ports
Back
Not used
Initial Configuration
Note: Wait for the system to boot before continuing with the procedure. This can
take up to 30 minutes.
2 Using an Ethernet cable, connect the Ethernet port on the computer to Ethernet
port 2 on the back of the DXi4000. Ethernet port 2 is in the far left-hand Ethernet
port in the middle PCI slot (slot 2) as you face the back of the system (see
Ethernet port 2
2
Gb 1
Gb 2
Service port (not
for customer use)
Not used
3 Configure the network settings on the computer:
Note: This procedure assumes you are running Windows XP on the computer. The
steps might be different if you are using another operating system.
1
3 4 5
2
3
DXi4000
Figure 9).
1
2
13