Quantum DXi4510 Installation And Configuration Manual page 27

Figure 23 NAS Wizard:
Confirm
Initial Configuration
• Enable data deduplication - Make sure the check box is selected to enable data
deduplication. (Data deduplication is enabled by default.)
• Hide from network browsing - Do not select this check box. If selected, you
cannot see the share when browsing the network.
8 Click Add.
9 Click Next to continue.
The Confirm page displays (see
10 Complete the NAS wizard:
a Review the settings you selected to make sure they are correct. If necessary, click
Previous to return to a previous step to make changes.
b To make changes to a NAS share you added, first select the share and click
Delete to delete the share. Then click Previous to return to the previous step
and add a new share.
c After you have confirmed all settings, click Finish. The NAS share is created and
becomes available on the Windows network.
11 To verify the NAS share:
a On a computer on the same network as the DXi4000, click Start and then Run.
b Type: \\<IP address of the DXi4000>\<name of the NAS share>
c Press Enter.
The NAS share will display the NAS share in Windows Explorer if successful.
12 The DXi4000 is now ready to use for backup operation. The installation is successful
when you are able to backup data to the system. Here are the next steps you can
take:
Figure 23).
DXi4000
27