Sonicwall Soho3 And Tele3 Back Panel - SonicWALL PRO 200 Installation Manual

There are two Ethernet ports; one of the following for the LAN and WAN ports:
• Link
Lights up when the Twisted Pair port is connected to a 10Mbps or 100Mbps hub or switch
or directly connected to a computer. Note that the connected Ethernet device must support
the standard Link Integrity test.
• 100
Lights up when the Twisted Pair port is connected to a 100Mbps hub or switch or directly
connected to a computer with a 100Mbps network interface.
• Activity
Flashes when the SonicWALL transmits or receives a packet through the Twisted Pair port.

SonicWALL SOHO3 and TELE3 Back Panel

The SonicWALL SOHO3 back panel is shown below, followed by a description of each item. The
SonicWALL TELE3 back panel is identical to the SonicWALL SOHO3.
Cooling Vents
Reset Switch
RS-232
Serial Port
The SonicWALL SOHO3 and TELE3 Back Panel Description
• Reset Switch
Erases the firmware and resets the SonicWALL to its factory clean state. This can be
necessary if you forget the administrator password or the firmware has become corrupt.
• Serial Port
DB-9 RS-232 Serial port
Page 72
10Mbps/100Mbps
LAN Ethernet Port
10Mbps/100Mbps
WAN Ethernet Port
5VDC,2A
Power Input