SonicWALL TZ 100 Series Getting Started Manual
  1. Manuals
  2. Brands
  3. SonicWALL Manuals
  4. Firewall
  5. TZ 200 Series
  6. Getting started manual

SonicWALL TZ 100 Series Getting Started Manual

Sonicwall network security appliances
Hide thumbs Also See for TZ 100 Series:
Table of Contents

Advertisement

Quick Links

SonicWALL Network Security Appliances
TZ 100 / TZ 200 Series
NET WORK SECURIT Y
Getting Started Guide

Advertisement

Table of Contents
loading

Related Manuals for SonicWALL TZ 100 Series

Summary of Contents for SonicWALL TZ 100 Series

  • Page 1 SonicWALL Network Security Appliances TZ 100 / TZ 200 Series NET WORK SECURIT Y Getting Started Guide...
  • Page 2 SonicWALL TZ 100/200 series Getting Started Guide This Getting Started Guide provides instructions for basic installation and configuration of the SonicWALL TZ 100/200 series appliance running SonicOS Enhanced. Document Contents This document contains the following sections: Setting Up Your Network...
  • Page 3 Page ii...

  • Page 4: Table Of Contents

    Setting Up Your Network In this Section: This section provides pre-configuration information. Review this section before setting up your SonicWALL TZ 100/200 series appliance. System Requirements • - page 2 Recording Configuration Information • - page 2 Completing the Setup Wizard •...

  • Page 5: System Requirements

    SonicWALL appliance. Supported Browsers Browser Version Authentication Code: Record the authentication code found on Number the bottom panel of your SonicWALL appliance. Internet Explorer 6.0 or higher Networking Information Firefox 2.0 or higher LAN IP Address:...
  • Page 6 (IP Address): Primary DNS: Primary DNS: Secondary DNS (optional): Secondary DNS (optional): Dial-in to a PPTP server Server Address: Dial-in to a PPTP server Server Address: User Name: User Name: Password: Password: SonicWALL TZ 100/200 Series Getting Started Guide Page 3...

  • Page 7: Completing The Setup Wizard

    After the Setup Wizard completes, the appliance may reboot. WAN Settings—Required for some WAN modes. This Please wait a few minutes while the SonicWALL appliance information is also provided by your ISP. reboots to save the updated firmware settings, and then continue with the next section of this guide.

  • Page 8: Accessing The Management Interface

    If the System > Status page (shown below) displays, then you have correctly configured the SonicWALL TZ 100/200 series The computer you use to manage the SonicWALL TZ 100/200 appliance to work with the computer on your LAN. series appliance must be set up to connect using DHCP, or with a static IP address in your chosen subnet.

  • Page 9: Verifying Wan (Internet) Connectivity

    Each interface may be configured for a Enter “http://www.sonicwall.com” in the address bar and different zone (LAN, WAN, DMZ) press Enter on the keyboard. The SonicWALL website Console Power displays. If you are unable to browse to a Website, see “Troubleshooting Internet Connection”...

  • Page 10: Troubleshooting Initial Setup

    This section provides troubleshooting tips for the following initial default IP address (192.168.168.168) for this. setup topics: • Is the Test LED on the front panel of your SonicWALL Troubleshooting the Setup Wizard • - page 7 appliance lit? If the Test LED stays lit for more than a Troubleshooting Internet Connection •...
  • Page 11 Configuring DHCP IP Addressing Windows XP From the Start menu, highlight Connect To and then If you are having trouble connecting to the SonicWALL TZ 100/ select Show All Connections. 200 series appliance, complete the following section based on Right-click on your Local Area Connection and select your Windows operating system flavor.

  • Page 12: Registering Your Appliance

    Registering and Licensing Your Appliance on MySonicWALL • - page 10 Note: Registration is an important part of the setup process and is necessary to receive the benefits of SonicWALL security services, firmware updates, and technical support. SonicWALL TZ 100/200 Series Getting Started Guide Page 9...

  • Page 13: Creating A Mysonicwall Account

    In the login screen, click the Not a registered user? link. Product Registration You must register your SonicWALL security appliance on MySonicWALL to enable full functionality. Login to your MySonicWALL account. If you do not have an account, you can create one at www.mysonicwall.com.
  • Page 14 Enforced Client Anti-Virus and Anti-Spyware • Global VPN Client • Global VPN Client Enterprise • ViewPoint • Support Services: • Dynamic Support 8x5 • Dynamic Support 24x7 • Software and Firmware Updates SonicWALL TZ 100/200 Series Getting Started Guide Page 11...
  • Page 15 Service Management page. You have successfully registered your SonicWALL appliance. And now you need to enable Unified Threat Management (UTM) security services. SonicWALL UTM security services are not enabled by default. Page 12 Registering and Licensing Your Appliance on MySonicWALL...

  • Page 16: Enabling Security Services

    Enabling Security Services In this Section: Security services are an essential component of a secure network deployment. This section provides instructions for registering and enabling security services on your SonicWALL TZ 100/200 series appliance. Enabling Security Services in SonicOS •...

  • Page 17: Enabling Security Services In Sonicos

    Enabling Content Filtering Service • - page 18 display as licensed, you need to synchronize your SonicWALL with the licensing server. If initial setup is already complete, click the Synchronize button to synchronize licenses from the System > Licenses page.
  • Page 18 See the following table for an explanation of these protocols. Tip: For a complete overview of GAV features, refer to the SonicOS Enhanced Administrator’s Guide. SonicWALL TZ 100/200 Series Getting Started Guide Page 15...
  • Page 19 Enabling Intrusion Prevention Services Click the Accept button to apply changes. To enable Intrusion Prevention (IPS) in SonicOS: Intrusion Prevention contains other useful features, including: Navigate to the Security Services > Intrusion Prevention • Exclusion Lists for network nodes where IPS page.
  • Page 20 Prevent all blocks attacks of the chosen priority, Detect All saves a log of these attacks which can be viewed in the Log > View screen. Click the Accept button to apply changes. SonicWALL TZ 100/200 Series Getting Started Guide Page 17...
  • Page 21 • URL Rating Review allows the administrator and users to review blocked URL ratings if they think a URL is rated Select SonicWALL CFS in the Content Filter Type drop- down list and then click the Configure button. incorrectly. •...
  • Page 22 For example, Advanced Deployments • - page 33 you can configure SonicWALL Intrusion Prevention Service for incoming and outgoing traffic on the WLAN zone to add more security for internal network traffic. To apply services to network zones: Navigate to the Network >...
  • Page 23 Page 20 Verifying Security Services on Zones...

  • Page 24: Advanced Network Configuration

    Advanced Network Configuration In this Section: This section provides detailed overviews of advanced deployment scenarios, as well as configuration instructions for connecting your SonicWALL TZ 100/200 series appliance to various network devices. An Introduction to Zones and Interfaces • - page 22 SonicWALL Wireless Firewalling •...

  • Page 25: An Introduction To Zones And Interfaces

    The security features and settings that zones carry are W0 WLAN Wireless Clients Wireless Devices enforced by binding a zone to one or more physical interfaces (such as, X0, X1, or X2) on the SonicWALL TZ 100/200 series appliance. Front Lobby Sales Marketing...

  • Page 26: Sonicwall Wireless Firewalling

    SonicWALL Wireless Firewalling SonicWALL addresses this security shortcoming by managing the SonicPoint access points from the UTM appliance. This When a wireless device uses an access point to communicate allows complete control of the wireless space, including zone with a device on another subnet or on a completely different...

  • Page 27: Configuring Interfaces

    Configuring Interfaces Note: If only X0 and X1 interfaces are displayed in the Interfaces, also known as ports, are physical network Interfaces list, click the Show PortShield Interfaces connections that can be configured to provide different button to show all interfaces. networking and security features based on your network needs.
  • Page 28 The SonicWALL PortShield feature enables WAN/LAN X1: WAN Connect Internet connection to X1 you to easily configure the ports on the SonicWALL TZ 100/200 All Other Ports: LAN Connect network devices to any remaining portfor local and Internet connectivity.

  • Page 29: Creating Network Access Rules

    Deny table is the Any rule. Note: SonicWALL’s default firewall rules are set in this way for ease of initial configuration, but do not reflect best practice installations. Firewall rules should only allow the required traffic and deny all other traffic.
  • Page 30 • Select a schedule from the Schedule drop-down list. The default schedule is Always on. • Enter any comments to help identify the access rule in the Comments field. SonicWALL TZ 100/200 Series Getting Started Guide Page 27...

  • Page 31: Address Objects

    Address Objects allow for the identification of a host by its your destination back to your source. domain name, such as www.sonicwall.com. Click on the QoS tab to apply DSCP marking to traffic governed by this rule.

  • Page 32: Network Address Translation

    NAT by default when traffic crosses between the other interfaces. Creating and Managing Address Objects You can create multiple NAT policies on a SonicWALL running The Network > Address Objects page allows you to create SonicOS Enhanced for the same object – for instance, you can and manage your Address Objects.
  • Page 33 IP Destination IP address, and Destination Services. Policy-based addresses are translated from the IP address of the SonicWALL NAT allows you to deploy different types of NAT simultaneously. security appliance WAN port to the IP address of the internal The following NAT configurations are available in SonicOS Web server.
  • Page 34 NAT policy to be automatically created in the opposite direction. This will create the outbound as well as the inbound NAT Policy. For more information on creating NAT policies, refer to the SonicOS Enhanced Administrator’s Guide. SonicWALL TZ 100/200 Series Getting Started Guide Page 31...
  • Page 35 Page 32 Network Address Translation...

  • Page 36: Support And Training Options

    Support and Training Options In this Section: This section provides overviews of customer support and training options for the SonicWALL TZ 100/200 series appliances. Customer Support • - page 60 Knowledge Portal • - page 60 Onboard Help • - page 61 SonicWALL Live Product Demos •...

  • Page 37: Customer Support

    Support Contract. Please review our Warranty Support Policy • Browse for product coverage. SonicWALL also offers a full range of • Search for keywords consulting services to meet your needs, from our innovative •...

  • Page 38: Onboard Help

    SonicWALL Live Product Demos SonicOS features a dynamic Onboard Help in the form of The SonicWALL Live Demo Site provides free test drives of helpful tooltips that appear over various elements of the GUI SonicWALL security products and services through interactive when the mouse hovers over them.

  • Page 39: User Forums

    User Forums The SonicWALL User Forums is a resource that provides users the ability to communicate and discuss a variety of security and appliance subject matters. In this forum, the following categories are available for users: • Content Security Manager topics •...

  • Page 40: Training

    Training SonicWALL offers an extensive sales and technical training curriculum for Network Administrators, Security Experts and SonicWALL Medallion Partners who need to enhance their knowledge and maximize their investment in SonicWALL Products and Security Applications. SonicWALL Training provides the following resources for its customers: •...

  • Page 41: Related Documentation

    Radio Frequency Monitoring • Single Sign-On • SSL Control • Virtual Access Points • SonicWALL GMS 5.0 Administrator’s Guide • SonicWALL GVC 4.0 Administrator’s Guide • SonicWALL ViewPoint 5.0 Administrator’s Guide • SonicWALL GAV 4.0 Administrator’s Guide • SonicWALL IPS 2.0 Administrator’s Guide •...

  • Page 42: Sonicwall Secure Wireless Network Integrated Solutions Guide

    This 512 page book is available in hardcopy. Order the book directly from Elsevier Publishing at: Integrated Solutions Guide <http://www.elsevier.com> The Official Guide to SonicWALL’s market-leading wireless networking and security devices. SonicWALL TZ 100/200 Series Getting Started Guide Page 65...
  • Page 43 Page 66 SonicWALL Secure Wireless Network Integrated Solutions Guide...
  • Page 44 F +1 408.745.9300 www.sonicwall.com P/N 232-001720-00 Rev A 05/09 ©2009 SonicWALL, Inc. is a registered trademark of SonicWALL, Inc. Other product names mentioned herein may be trademarks and/or registered trademarks of their respective companies. Specifications and descriptions subject to change without notice.

Table of Contents