SonicWALL PRO 200 Installation Manual page 76

• Receive (RX)
The RX light is lit when data is received over the network connection.
• Link
The Link LED indicates that the interface is connected to a valid link partner and is
receiving link pulses.
The 1000Base-T network interface has the following LEDs:
• Link
The Link light is green when a network connection is made to another Ethernet device
(usually a hub) on the port.
• Activity
The Activity LED blinks, indicating Activity, when the SonicWALL transmits or
receives a frame.
• Network Speed
The Network Speed light remains off if there is no connection or if a 10Mbps
connection is made. If a 100 Mbps connection is made, the LED is green. If a 1000
Mbps connection is obtained, the LED is yellow.
Reset Switch
Resets the SonicWALL GX 250 or the SonicWALL GX 650 to its factory clean state. This may be
required if you forget the administrator password, or the SonicWALL firmware has become
corrupt.
SonicWALL GX 250 and GX 650 Rear Panel
The SonicWALL GX 250 back panel is shown below, followed by a description of each item.
SonicWALL GX 650 back panel is identical to the SonicWALL GX 250.
Cooling Vent
SonicWALL GX 250 and SonicWALL GX 650 Back Panel Description
• Power Inputs
Alarm Reset Button
Power
Switches
SonicWALL Installation Guide Page 75
The
Power Input