Sonicwall Pro 100 Back Panel - SonicWALL PRO 200 Installation Manual

There are three Ethernet ports; one for each of the LAN, DMZ, and WAN ports:
• Link
Lights up when the Twisted Pair port is connected to a 10Mbps or 100Mbps hub or switch,
or directly connected to a computer. Note that the connected Ethernet device must support
the standard Link Integrity test.
• 100
Lights up when the Twisted Pair port is connected to a 100Mbps hub or switch or directly
connected to a computer with a 100Mbps network interface.
• Activity
Flashes when the SonicWALL PRO 100 transmits or receives a packet through the Twisted
Pair port.

SonicWALL PRO 100 Back Panel

The SonicWALL PRO 100 back panel is shown below, followed by a description of each item.
Cooling Vents
Reset Switch
RS-232
Serial Port
The SonicWALL PRO 100 Back Panel Description
• Reset Switch
Erases the firmware and resets SonicWALL PRO 100 to its factory clean state. This can be
necessary if the administrator password is forgotten, or the firmware has become corrupt.
Instructions for erasing the SonicWALL firmware are Guide.
• Serial
DB-9 RS-232 Serial port.
• (3) Twisted Pair (10Base-T, 100Base-T) Ethernet Ports
(3) Auto switching 10Mbps/100Mbps Ethernet ports provide connectivity for both Ethernet
and Fast Ethernet networks. The Ethernet ports connect the SonicWALL PRO 100 to the
LAN, DMZ, and WAN using Twisted Pair cable with RJ45 connectors.
Page 70
10Mbps/100Mbps
10Mbps/100Mbps
DMZ Ethernet Port
LAN Ethernet Port
5VDC,2A
Power input
10Mbps/100Mpbs
WAN Ethernet Port