Troubleshooting - Lutron Electronics Sivoia QED Installation Instructions Manual

Troubleshooting

12
Symptom
EDU will not move...
Blind does not fully open or fully close...
Fabric not level...
Fabric not centered over window...
Blind does not move smoothly...
IR controls will not operate blind....
SIVOIA QED Jamb Mount Installation Instructions
®
Solution
...EDU is not powered - check EDU Power.
...Blind is caught on something - free blind.
...Blind is not assigned to keypad, IR, or CCI.
...Limits set at same place.
...Limits have been set incorrectly - refer to "set
open limit" and "set close limit" sections.
...Blind fabric is caught on something - free blind.
...Adjust using level adjustment screw.
...Check that brackets are mounted level.
...Check that fabric is tracking correctly on
the blind tube.
...Center blind using center adjustment.
...Check that brackets are centered.
...Check for binding of blind fabric on
side channels.
...Check fabric tracking.
...IR transmitter does not have line-of-sight to
IR receiver.
...Out of range - move to within 12 m (40 ft) of
IR receiver.
...EDUs not assigned to IR receiver.
...IR receiver not plugged into any EDU within range.
...Batteries are not providing power, replace them.
...IR receiver not properly oriented.
15