Chapter 5 Troubleshooting; Troubleshooting Guide - Olympus EVIS EXERA II Operation Manual

Chapter 5 Troubleshooting

Chapter 5 Troubleshooting
5.1

Troubleshooting guide

64
If the endoscope is visibly damaged, does not function as expected, or is found
to have irregularities during the inspection described in Chapter 3, "Preparation
and Inspection", do not use the endoscope. Contact Olympus.
Some problems that appear to be malfunctions may be correctable by referring
to Section 5.1, "Troubleshooting guide". If the problem cannot be resolved by the
described remedial action, stop using the endoscope and send it to Olympus for
repair.
Olympus does not repair accessory parts. If an accessory part becomes
damaged, contact Olympus to purchase a replacement.
• Never use the endoscope on a patient if an irregularity is
observed. Damage or an irregularity in the instrument may
compromise patient or user safety and may result in more
severe equipment damage.
• If any parts of the endoscope fall off inside the patient body
due to equipment damage or failure, stop using the
endoscope immediately and retrieve the parts in an
appropriate way.
Should any irregularity in the function of the endoscope and/or endoscopic
image be observed during use, stop the examination immediately and carefully
withdraw the endoscope from the patient as described in Section 5.2,
"Withdrawal of the endoscope with an irregularity" on page 68.
The following table shows the possible causes of and countermeasures against
troubles that may occur due to equipment setting errors or deterioration of
consumables.
Troubles or failures due to other causes than those listed below should be
serviced. As repair performed by persons who are not qualified by Olympus
could cause patient or user injury and/or equipment damage, be sure to contact
Olympus for repair following the instructions given in Section 5.3, "Returning the
endoscope for repair" on page 70.
EVIS EXERA II TJF TYPE Q180V OPERATION MANUAL