Olympus EVIS EXERA II Operation Manual page 56

Chapter 4 Operation
Operation of EndoTherapy accessories
52
• When inserting an EndoTherapy accessory, hold it close to
the biopsy valve and insert it slowly and straight into the
biopsy valve. Otherwise, the EndoTherapy accessory and/or
biopsy valve could be damaged. This can reduce the efficacy
of the endoscope's suction system and may leak or spray
patient debris or fluids, posing an infection control risk.
1.
Select EndoTherapy accessories compatible with the instrument from the
"System chart" in the Appendix. Refer to the accessories' instruction
manuals for operating instructions.
2.
Raise the forceps elevator by turning the elevator control lever in the "
direction until the operator feels heavy.
3.
Hold the UP/DOWN and RIGHT/LEFT angulation knobs stationary.
4.
Confirm that the tip of the EndoTherapy accessory is closed or retracted into
its sheath and insert the EndoTherapy accessory slowly and straight into the
slit of the biopsy valve.
Do not open the tip of the EndoTherapy accessory or extend
the tip of the EndoTherapy accessory from its sheath while
the accessory is in the instrument channel. The instrument
channel and/or the EndoTherapy accessory may become
damaged.
5.
Hold the EndoTherapy accessory approximately 4 cm from the biopsy valve
and advance it slowly and straight into the biopsy valve using short strokes
while observing the endoscopic image. Confirm that the tip of the
EndoTherapy accessory contacts the forceps elevator.
6.
Move the elevator control lever in the opposite direction of the "
direction to lower the forceps elevator. Advance the EndoTherapy
accessory slightly and move the elevator control lever in the "
Confirm that the accessory appears in the endoscopic image.
7.
Manipulate the elevator control lever to adjust the height of the elevator.
Operate the EndoTherapy accessory according to the directions given in its
instruction manual.
EVIS EXERA II TJF TYPE Q180V OPERATION MANUAL
U"
U"
U" direction.