Table of Contents
Advertisement
Connecting inverter to battery box
Readying charging cables for use and connecting them
Disconnecting the plug from the charging cable
Follow the steps below if you have to discon-
nect the plug from the charging cable during
installation.
A
5
1. Open the cable gland using an M12 open-end
wrench.
2. Insert the screwdriver at Position A and carefully push
outwards until the plug comes loose.
3. Pull apart the two housing parts of the plug.
4. On the housing section with the cable, pry up the
spring using a screwdriver and slide into the front
housing section.
5. Pull out the cable.
36
3
1
2
4
Disconnecting the plug from the connection to the bat-
tery box
Follow the steps below if you have to discon-
nect the plugs with the charging cable from the
connection to the battery box.
1. Slide a flat screwdriver with a max. 3 mm blade into
the unlocking opening of the plug connector and pull
out the plug with the charging cable.
Installation Instructions for the Hybrid E5 Battery Storage System EU V1 EN 2018-09-17
Advertisement
Table of Contents
