Board And Se-656 Board - Sony SNC-RZ30N Service Manual

1-4-6. MDR-19 Board and SE-656 Board
1. Remove the front cover. (Refer to Section 1-2-1)
2. Remove the upper cover and lower cover. (Refer to
Section 1-2-2)
3. Remove the pan cover (F) and pan cover (B). (Refer to
Section 1-2-3)
4. Remove the pan cover (R) and pan cover (L). (Refer to
Section 1-2-4)
5. Remove the SY-303 board. (Refer to Section 1-4-5)
6. Remove the four screws (M 2x4), then remove the
MDR-19 board.
7. Disconnect the three flexible flat cables and the three
harnesses from the six connectors on the MDR-19
board.
8. Remove the four screws (M 2.6x4), then remove the
DC motor.
9. Remove the two screws (M 2x3), then remove the SE-
656 board.
10. Disconnect one harness from the connector on the SE-
656 board.
1-10
DC motor
SE-656 board
M 2x3
Connector
Harness
MDR-19 board
Harness
M 2x4
11. Install the MDR-19 board and SE-656 board in the
reverse order of steps 1 to 10.
n
When installing the MDR-19 board and SE-656 board, be
careful not to get the flexible flat cable or harness caught in
the boards.
M 2.6x4
Base chassis
Connector
Flexible
flat cables
Connector
Harnesses
SNC-RZ30N/RZ30P (E)