Advertisement
4
vacon
HAZARDOUS VOLTAGE
• Disconnect all power before servicing a drive unit or its components. WAIT 5 MINUTES until the DC
bus capacitors discharge.
• Ensure that any other power sources that may feed control logic have been disconnected.
• DO NOT short across DC bus capacitors or touch unshielded components or terminal strip screw
connections with voltage present.
• Install all covers before applying power or starting and stopping the drive.
• The user is responsible for conforming to all applicable code requirements with respect to grounding
all equipment.
• Many parts in a drive, including printed circuit boards, operate at line voltage. DO NOT TOUCH. Use
only electrically-insulated tools.
Before servicing any drive.
• Disconnect all power.
• Place a "DO NOT TURN ON" label on the drive disconnect.
• Lock the disconnect in the open position.
Failure to observe these precautions will cause shock or burn, resulting in severe personal injury
or death.
Figure 1 shows the option board and the location of the terminals and the power supply selector.
Module Status LED
Figure 1: Option Board Layout
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
X5EIP01 Ethernet IP with 115 VAC / Encoder Interface Option Board
!
DANGER
Encoder / 115 VAC Interface
Control Relay Terminals
Encoder Interface Power
Network Status LED
Ethernet Connector
Supply Selector
Advertisement
