Advertisement
X5EIP01 Ethernet IP with 115 VAC / Encoder Interface Option Board
vacon
5
Before you can install the option board, you must first remove the drive cover.
Figure 2 shows the locations of the cover screws. The torque range for the X5 Size 1 cover is 18-26 in/lbs.
Cover screw locations
Cover screw locations
Figure 2: Cover Assembly and Screw Locations
The option board is installed just above the control board in all configurations (a Size 1 unit is shown in Figure 3 for
reference). The screws labeled "A" must be removed from the X5; those labeled "B" need only to be loosened to
accept the board slot.
.
B
B
A
A
Figure 3: Option Mounting Locations
Once the board is in place, tighten the screws to a maximum of 26 in-lbs.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Advertisement
