ASSEMBLY
TOOLS NEEDED FOR MOUNTING OF THE STOVE
¬
Spirit level
¬
Cutting nippers
LOOSE PARTS
The loose parts are located in the stove's ash drawer.
¬
Glove
¬
4 pcs. screws for fastening the connecting piece
¬
Fresh air intake
¬
1 pcs. screw M5x6, must be placed for United Kingdom
ADDITIONAL ACCESSORIES
¬
Small shaped floor plate in glass or steel
¬
Natural stones top plate for stove with rear outlet
¬
Scan 65-7/8 and 65-9/10: Heat accumulating stones
DISPOSAL OF PACKAGING
Your Scan stove may come supplied with the following packaging:
Wood packaging
Polystyrene top
Foam
Plastic bags
Stretch/plastic film
FRESH AIR INTAKE
In a well-insulated house, the air used up by the burning process has to be replaced. This particularly applies to houses with
mechanical ventilation. There are different ways of making sure that an air exchange takes place. The most important thing is to
ensure that there is a supply of air to the room where the wood stove is located. The external wall vent must be located as close
to the wood stove as possible, and you must be able to close it when you are not using the wood stove.
National and local building regulations must be followed with regard to the connection of fresh-air intake.
The wood packaging can be reused and after final use can be incinerated as a CO
product or sent for recycling.
Send for recycling or waste disposal
Send for recycling or waste disposal
Send for recycling or waste disposal
Send for recycling or waste disposal
¬
Open-end spanner
¬
Seal for the connecting piece
¬
Scan 65-3 and Scan 65-4: 4,5 m gasket
¬
Scan 65-7 and Scan 65-8: 7 m gasket
¬
Large shaped floor plate in glass or steel
¬
Natural stones top plate for stove with top outlet
neutral
2
11