Advertisement
Turning on the Labware MiniHub
Turning off the Labware MiniHub
Using Labware MiniHub Diagnostics in the VWorks software
About Labware MiniHub Diagnostics
Labware MiniHub Quick Guide
The Labware MiniHub does not have a power switch. You turn on and turn off
the device by connecting or disconnecting the power cord. If it is integrated in
a workstation, you use the Automation Control Unit to turn on and turn off
the device.
CAUTION
The Labware MiniHub will rotate during the startup process. Obstructing the
Labware MiniHub while it is rotating will cause an error.
To turn on the Labware MiniHub:
Connect the male end of the Labware MiniHub power cord to an appropriate,
grounded power source. The Labware MiniHub rotates slowly to its factory- set
home position.
If the Labware MiniHub is integrated in a workstation, see the workstation
user documentation.
To turn off the Labware MiniHub:
Disconnect the power cord from the power source.
If the Labware MiniHub is integrated in a workstation, see the workstation
user documentation.
This topic explains how to control the Labware MiniHub using Diagnostics in
the VWorks software. For information on controlling the Labware MiniHub
using diagnostics in the Encore Multispan software, see
Diagnostics in the Encore Multispan software" on page
The Labware MiniHub Diagnostics software has two tabs: Controls and Profiles.
You use the commands in the Profiles tab to establish communication with the
Labware MiniHub. You use the commands and parameters available in the
Controls tab to control or move the device.
If you are using a different automation software, call the VWorks ActiveX
ShowDiagsDialog method to open Labware MiniHub Diagnostics. For details,
see the
Labware MiniHub User
Using Labware MiniHub Diagnostics in the VWorks software
Guide.
"Using MiniHub
14.
5
Advertisement
