Advertisement
Changing the rotation speed
Labware MiniHub Quick Guide
•
Want to remove labware from specific shelves after a run error occurs.
After setting the home position or fixing the error, you can enable the Labware
MiniHub's motor to resume operation.
CAUTION
The Labware MiniHub might rotate slightly when you enable the motor.
Obstructing the Labware MiniHub while it is rotating will cause an error.
To enable or disable the Labware MiniHub motor:
In the Controls tab, click Enable or Disable.
Note: When the motor is enabled, the green Enabled light turns on in the Motor
area. When the motor is disabled, the Enabled light turns off.
You can select the speed at which the Labware MiniHub turns while you are
making adjustments in Labware MiniHub Diagnostics. For example, you can
select the Slow speed when you are setting up or troubleshooting the hub.
Note: To set the rotation speed for protocol runs, use the Speed selection in
the Profiles tab.
To select the diagnostic rotation speed:
In the Controls tab, select one of the following speeds from the Speed list:
Using Labware MiniHub Diagnostics in the VWorks software
9
Advertisement
