Kioti KL155 Manual page 52

PROBLEM POSSIBLE CAUSE
Hydraulic pump capacity
inadequate. Hydraulic pump defective.
Lift cylinder rod bend
Excessive shock load on lift cylinders during
when lift cylinders
transport.
extended.
Bucket cutting edge
wear is uneven side to Bucket is not level to ground.
side
B u c k e t cu t t i ng e d g e
Incorrect operational practices. Excessive
wear rate is excessive.
down pressure placed on bucket when being
( W e a r r a t e i s e v e n
used on hard abrasive surfaces.
a c r o s s f u l l w i d t h o f
bucket).Note: Extensive
u s e o f b u c k e t o n
c o n c r e t e o r a s p h a l t
surfaces will accelerate
Bucket wear pads worn.
w e a r r a t e o f b u c k e t
cutting edge.
TROUBLE SHOOTING 10-7
CORRECTION
Refer to Tractor Operator's Manual for
recommended service procedures. Replace
hydraulic pump if determined to be defective.
Replace defective parts. Review and observe
proper and safe operational practices.
Check rear tire inflation and adjust to level
bucket to ground.
Refer to operation-scraping section for
correct operating procedures. Utilize float
position.
Replace wear pads.
10