Kioti KL155 Manual page 30

Initial Loader Operation
Before operating the loader, fully raise and lower the boom two
or three times. Then raise the bucket approximately four(4) feet
above the ground and cycle the bucket cylinders three times.
Lower the bucket to the ground. Check the tractor hydraulic oil
and the correct oil level.
Always keep cylinders in a retracted position when the loader is
not in use to guard against rust and contamination which may
cause damage to the cylinder rods or hydraulic system.
Cold Weather Operation
for smooth operation in cold weather, let the tractor warm up.
Slowly cycle the lift and bucket cylinders several times to
warm the oil in the hydraulic system. The loader may operate
erratically until the hydraulic oil has warmed to operating
temperatures.
Loading Bucket
For the most efficient loading, slowly drive the tractor
straight into the material to be loaded and increase speed
only after contact has been made. Roll the attachment back
a small amount and slowly lift to break away the material. As
the load increase, continue rolling the attachment back so
as to get the maximum load. Remove the top levels first
when loading from large piles of material. When bucket is
full, raise loader so the bucket is clear of material and slowly
back out of the pile.
Dumping Bucket
When in the dump area slowly drive the tractor forward and
raise the loader at the same time. Raise the loader to the
height needed to dump the bucket. Make sure to keep a
level bucket position to prevent spilling from the bucket.
Dump the bucket, and keep all movements smooth.
LOADER OPERATION 6-3
6