Kioti KL155 Manual page 40

STEP 3.
Start the engine and move the boom and bucket to adjust
the height of loader.
Be sure to check the hook of mounting frame is slightly
higher than the pin welded on loader post.
STEP 4.
Move the tractor forward to put the mounting frame into
the loader post. Stop the tractor when the hook is right
over the pin.
Lower the loader post with moving the boom and bucket
until it hooked securely each other.
STEP 5.
Align the latch pin holes with moving the bucket and
boom. Insert the latch pins.
Rubber hammer can be used to put the pin in if needed.
LOADER REMOVAL 7-3
8