Martin Exterior Projection 500 User Manual page 6

Install, operate and service Martin products only as directed in their user manuals
or you may create a safety hazard or cause damage that is not covered by
product warranties.
Keep this user manual for future use. Before installing, using or servicing this
fixture, check that you have the latest version of the user manual, available on the
fixture's Tech Docs/Support page on the Martin website at http://www.martin.com.
Martin user manual versions are identified by the Revision letter given at the
bottom of page 2.
Refer any operation not described in this user manual to Martin Global Service or
an authorized Martin service agent.
Follow the safety precautions listed below and observe all warnings in this manual
and printed on the fixture.
Protection from electric shock
This fixture is IP66 rated. It is suitable for use in wet locations, but do not immerse
it in water or install it in a location where it may become submerged.
This fixture is a Class I product according to IEC 61140. Ensure that the fixture is
electrically connected to ground (earth).
Disconnect the fixture from AC power when it is not in use.
Use only a source of AC power that complies with local building and electrical
codes and has both overload and ground-fault (earth-fault) protection.
The circuit used to supply the fixture with AC power must include a power switch
that is easily accessible so that the fixture can easily be disconnected from power.
Shut down power to the entire installation at the main power distribution board
and lock out power before carrying out any installation or maintenance work.
Isolate the fixture from power immediately if any seal, cover, cable, connector or
other component is damaged, defective, deformed, wet or showing signs of
overheating. Contact Martin for any service operation not described in this user
manual. Do not reapply power until repairs have been completed
Before using the fixture, check that all power distribution equipment and cables
are in perfect condition, are rated for the current requirements of all connected
devices, are protected to IP67 or higher and are of suitable type for the location
(including water, pollution, temperature and UV resistance).
Protection from burns and fire
Do not operate the fixture if the ambient temperature (T ) exceeds 45° C (113° F).
a
The surface of the fixture casing can reach up to 85° C (185° F) during operation.
Avoid contact by persons and materials. Allow the fixture to cool for at least 10
minutes before handling.
Keep flammable materials well away from the fixture. Keep combustible materials
(e.g. fabric, wood, paper) at least 0.1 m (4 ins.) away from the fixture housing.
Ensure that there is free and unobstructed airflow around the fixture.
Do not illuminate surfaces within 0.5 m (1.6 ft.) of the front glass.
Do not modify the fixture in any way not described in this manual or install other
than genuine Martin parts. Do not stick filters, masks or other materials onto any
lens or other optical component. Use only accessories approved by Martin™ to
modify the light beam.
The fixture's optical components can focus the sun's rays, creating a risk of fire
and damage. Do not expose the front of the fixture to sunlight or any other intense
light source.
6 Exterior Projection 500 User Manual