Remote Device Management (Rdm); Setting Beam Angles In New Firmware; Parameter Ids - Martin Exterior Projection 500 User Manual

Remote Device Management (RDM)

The Exterior Projection 500 features Remote Device Management (RDM) capability. RDM lets you
get information from the fixture and change settings in the fixture remotely over the DMX data link
using an RDM-compatible DMX controller.

Setting beam angles in new firmware

If you update the fixture's firmware to version 1.6.0 or later, you can use RDM to set the correct
beam angle in Narrow, Wide and Very Wide beam angle fixtures without needing physical access
to the fixture (see 'Setting beam angles when updating firmware' on page 43).

Parameter IDs

RDM commands are normally referred to as Parameter IDs or PIDs. The Exterior Projection 500
responds to the following Parameter IDs:
Device discovery
Parameter ID
DISC_UNIQUE_BRANCH
DISC_MUTE
DISC_UN_MUTE
Device management
Parameter ID
COMMS_STATUS
QUEUED_MESSAGE
STATUS_MESSAGES
STATUS_ID_DESCRIPTION
CLEAR_STATUS_ID
SUPPORTED_PARAMETERS
PARAMETER_DESCRIPTION
DEVICE_INFO
DEVICE_MODEL_DESCRIPTION
MANUFACTURER_LABEL
DEVICE_LABEL
FACTORY_DEFAULTS
SOFTWARE_VERSION_LABEL
DMX_PERSONALITY
DMX_PERSONALITY_DESCRIPTION
DMX_START_ADDRESS
SLOT_DESCRIPTION
44 Exterior Projection 500 User Manual
GET SET










 
 

 

 
