Martin Exterior Projection 500 User Manual page 13

2. Put on heat-resistant gloves.
3. See 'Anchoring to a surface or structure' on page 11. Loosen the bolts in the center hole A and
curved slots C slightly, just until you can rotate the yoke.
4. See illustration on right. Loosen the tilt lock Allen
(hex) screws (arrowed) on both sides of the yoke
slightly, just until you can tilt the fixture in the yoke.
5. Pan and tilt the fixture until it is aimed correctly.
6. Use a torque driver and tighten the four tilt
adjustment screws to a torque of 1.8 – 2.3 Nm.
7. See 'Anchoring to a surface or structure' on page 11. Tighten the bolts in the center hole A and
curved slots C and install bolts in holes B. Check that the fixture will be held securely in all
wind and weather conditions.
Exterior Projection 500 User Manual 13