Martin Exterior Projection 500 User Manual page 50

Master/Slave
Fixture
Config
Offline mode
Fixture Status
Password
Select variant
Service
Select Beam Angle
Fixture Offset
Evaporation Mode
Default settings are shown in bold.
50
Master
Slave
Run show
DMX last state
Black out
LED
XXX C
Temperature
Power-on XXXX
Hours (Hours)
XXXX
LED Hours
(Hours)
Software
V x.x.x
Version
0...999
EP500-MG
EP500-FR
Medium
Other
Password 0...999
Color -128~127
Gobo -128~127
etc... etc...
Password 0...999
Exterior Projection 500 User Manual
Set fixture to act as master or slave
If fixture is set to master and no DMX
signal is present, it runs standalone
show
If fixture is set to master and no DMX
signal is present, it displays the last
effect it was displaying before the
DMX signal stopped
When no DMX signal is present,
fixture blacks out
Temperature of LED engine
Number of hours fixture has been
powered on since manufacture
Number of hours light output has
been activated since manufacture.
Currently installed software
(firmware) version
Set user password (factory default
password is set to 123 but you can
set a new password here)
Match software to fixture variant:
select MG for Exterior 500 Projection
Multigobo, select FR for Exterior 500
Projection Framing
Match software to fixture variant:
select MEDIUM in Medium beam
angle fixtures, select OTHER in
Narrow, Wide and Very Wide
fixtures.
Note: For use by Martin Service!
Enter user password (default = 123) or
service password (111) for access to
effect offsets. Then set an offset in each
effect's home position.
Enter user password (default = 123) or
service password (111) for access to
Evaporation Mode. To clear humidity,
open top cover slightly, then press Enter.
When message to close cover appears in
display, close top cover and press Enter.