Martin Exterior Projection 500 User Manual page 17

The Exterior Projection 500 is supplied with a hard-wired 1.8 m (5.9 ft.) shielded cable with 2 pairs
of wires for connection to a DMX data link.
The pair of wires with a green sleeve is for data input from the control device or previous device in
the daisy chain. The pair of wires with a brown sleeve is for data output (throughput) to the next
device in the daisy chain.
Connect the cable as shown in the table below. Do not connect the shield conductor to ground
(earth) or allow it to come into contact with a connector shell, as this may cause interference.
Wire color
Signal
Male XLR
pinout
Female XLR
pinout
Exterior 500 Projection DMX data cable
Input wires
(green sleeve)
white green
DMX in + DMX in –
pin 3 pin 2
- -
Data connection pinout
Exterior Projection 500 User Manual
Output wires
(brown sleeve)
white brown
DMX out + DMX out –
- -
pin 3 pin 2
Shield
black
common
pin 1
pin 1
17