Application.switchunittable.switchunitentry.swsize; Application.switchunittable.switchunitentry.swmembers; Application.switchunittable.switchunitentry.swposition; Application.numberofports - DEV 2190 User Manual

User Manual DEV 2190
5.5.4.3.7.2

.application.switchUnitTable.switchUnitEntry.swSize

OID:
Syntax:
Access:
Description:
5.5.4.3.7.3

.application.switchUnitTable.switchUnitEntry.swMembers

OID:
Syntax:
Access:
Description:
Example:
5.5.4.3.7.4

.application.switchUnitTable.switchUnitEntry.swPosition

OID:
Syntax:
Access:
Description:
Note:

.swPosition is used to perform the switching via SNMP in Remote Mode.

5.5.4.3.8 .application.numberOfPorts

OID:
Syntax:
Access:
Description:
Example:
Note:

This value determines the maximum index of the following table:
76
.1.3.6.1.4.1.21035.41.2.7.1.2.x
INTEGER32
read-only
The size of the switch unit (here: redundancy unit).
Due to the 2:1 redundancy switch applied with a redundant ampli-
fier option, "2" is returned.
.1.3.6.1.4.1.21035.41.2.7.1.3.x
OCTET STRING
read-only
A comma separated string that is interpreted as integers, con-
taining the indices of the ports in the .portTable (please refer to
chapter 5.5.4.3.9) being member of the switch unit (here: redun-
dancy unit).
first redundancy unit: "1,2,", second redundancy unit: "3,4," (...)
.1.3.6.1.4.1.21035.41.2.7.1.4.x
INTEGER32
read-write
The switching status of the corresponding switch unit (here: redun-
dancy unit). By writing to .swPosition the switching state can be
altered; possible values:
"1" the unit is (to be) switched to the main channel;
"2" the unit is (to be) switched to the backup channel.
.1.3.6.1.4.1.21035.41.2.8.0
INTEGER32 (0..255)
read-only
The number of ports with special properties within the device.
Each amplifier module is considered as a single port.
"4" for a device with 4 amplifier modules
 Copyright DEV Systemtechnik GmbH 2009-2017