Canon CX-G6400 User Manual page 181

Error Message
Paper Length different X
("X" represents number)
Paper Width different
Paper jam XX
("XX" represents numbers)
Feeder tray overloaded
List of Error Messages/Warning Messages
Error Content
The length of the paper that is
set differs from the paper size
configured by the application
software or printer driver.
The width of the paper that is
set differs from the paper size
configured by the application
software or printer driver.
The transport area, feeder
slot, or paper delivery slot is
clogged with paper.
The amount of paper loaded
in the feeder lift tray is over the
limit.
Handling
If the paper is different, replace
with the proper paper.
If the application software or
printer driver's configuration
is different, click on the Status
Monitor's [Cancel Print Job]
and print again after correctly
configuring the paper size.
If the paper is different, replace
with the proper paper.
If wrong paper is loaded or the
side guide is displaced, replace
with correct paper or move
the side guide to the correct
position.
If the application software or
printer driver's configuration
is different, click on the Status
Monitor's [Cancel Print Job]
and print again after correctly
configuring the paper size.
Remove the paper jam and
reload the paper. P.15
（→
If the same error occurs again,
update the printer drivers and
firmware to the latest versions.
Load paper so that the number
of sheets is less than the
specified amount and the top
surface of the paper stack is
lower than the paper loading
limit mark. P.19
（→ ）
）
177