Securam ProLogic L66 Operation Instructions Manual page 5

ProLogic L66
1.5 Testing the Lock Operation
The ProLogic L66 comes with two factory default codes:
• Super Code (ID00) is 111111
• Manager Code (ID01) is 123456
Enter one of the valid codes to verify that the communication between the lock and EntryPad. The lock
will open.
2.0 Code Length Options
IMPORTANT: This must be completed before any programming.
The ProLogic L66 allows you the ability to select the code length for all safe lock operators and the total
number of users allowable on the lock. Setting the code length and number of Users is a global setting
and applies to all safe lock operators.
There are 3 options available as follows:
Code Length 6 digits – 10 total codes available - This is the default mode and meets the UL

requirement.
Code Length 8 digits – 30 total codes available – This mode also meets the UL requirement.

Code Length 6 digits – 30 total codes available – This mode does not meet the UL requirement.

2.1 PW L – 6; Users – 10 – This is the default mode
NOTE: This operation must be performed with the safe door open and with access to the back of the
lock, as a mechanical reset must be performed during this programming sequence.
Step1: Press the Menu/OK button.
Step 2: Using the  and , scroll to the System Menu and Press Menu/OK.
Operation Instructions
5