Table of Contents
Advertisement
Powering up a Wilson Electronics Signal Booster
1 . To verify proper installation of the signal booster and antennas, make sure that the
distance between the inside and outside antennas is a minimum of 50 feet .
2 . Never point the front of a directional antenna toward the other, inside or outside, antenna .
See Figure 1 below .
3 . Ensure that both the outside antenna coax cable and the inside antenna coax cable are
connected to the signal booster and the connections are tight before powering up the
signal booster .
4 . Plug the 6-volt power supply into the signal booster input marked "6V DC" (carefully, to
avoid damaging the center pin) and then into a wall outlet .
5 . If the signal booster has a red light, or a blinking red light, please see page 4 .
6 . If you know that only one frequency band (800 or 1900) is available in your coverage area
(or going to be used), reduce the gain control on the frequency band that is NOT in use to
the minimum . This will reduce the power consumption of the signal booster .
7 . Using multiple boosters in one installation could cause degraded cell tower operation .
8 . Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660, or
email at tech@wilsonelectronics .com . Technical Support hours are 7 am until 6 pm MST .
Figure 1
INCORRECT INSTALLATION
3
Contact Wilson Electronics Technical Support Team with any questions at 866-294-1660
or email: tech@wilsonelectronics.com. Hours: 7 am to 6 pm MST.
Never point antennas toward each other
Outdoor
Antenna
Panel
Antenna
Signal booster
Advertisement
Table of Contents
