Installation Overview - Wilson Electronics 801105 Installation Manual

Installation Overview

The following steps provide a summary of the signal booster/antenna installation process.
However, they are not a substitute for the complete installation instructions on the following
pages, which you should read thoroughly. Contact Wilson Electronics Technical Support
Department with any questions at 877-594-5766.
STEP 1 Install the Outside Antenna
Mount the Yagi antenna so that it points toward the cell tower and away from where the
inside antenna will be located. Depending on your signal booster model, the two antennas
will need 50-75 feet of separation. (See illustrations on pages 5 and 7.)
STEP 2 Install the Inside Antenna
Select a location in the center of where the signal needs to be amplified. Refer to the
instructions included with the inside antenna. (See illustration on page 6 to determine the
inside antenna model that best meets your specific needs.)
STEP 3 Install the Signal Booster
Position the signal booster in a well-ventilated location near a power outlet. Attach the
outside and inside antennas to the signal booster using Wilson 400 low loss coax cable
(available from Wilson Electronics).
STEP 4 Power up the Signal Booster
IMPORTANT! Before connecting the power supply, ensure that both the inside and outside
antenna cables are connected. Also ensure that all cell phones and cellular data cards
within 50 feet of the inside antenna are turned off. Plug in the supplied 6-volt power supply
into the signal booster and then into a wall outlet (power supply sold separately in 801175).
STEP 5 Check the Signal Booster Lights
The PWR light should be green, indicating that the signal booster has power. If all other
lights are also green, the signal booster is operating properly; however, if you do not have
the desired signal coverage area, refer to pages 5, 6, 9 and 10.
Note: if you are using an outdoor Yagi antenna, it must be adjusted for maximum signal.
3
Contact Wilson Electronics Technical Support Team with any questions at 877-594-5766
or email: tech@wpsantennas.com. Hours: 7 am to 6 pm MST.