Use As Directed; Prohibited Use - Kollmorgen AKD PROFINET RT Communication Manual

Hot surface!
Drives may have hot surfaces during operation. The heat sink can reach temperatures above
80°C. Risk of minor burns! Measure the temperature, and wait until the heat sink has cooled
down below 40 °C before touching it.
Earthing!
It is vital that you ensure that the drive is safely earthed to the PE (protective earth) busbar in
the switch cabinet. Risk of electric shock. Without low-resistance earthing no personal pro-
tection can be guaranteed and there is a risk of death from electric shock.
High voltages!
Wait at least 7 minutes after disconnecting the drive from the main supply power before
touching potentially live sections of the equipment (such as contacts) or removing any con-
nections.
Capacitors can have dangerous voltages present up to seven minutes after switching off the
supply power. Always measure the voltage in the DC bus link and wait until the voltage is
below 60 V before handling components.
Never modify the drive!
It is not allowed to modify the drive without permission by the manufacturer. Opening the
housing causes loss of warranty.

3.3 Use as directed

Drives are components that are built into electrical plants or machines and can only be oper-
ated as integral components of these plants or machines. The manufacturer of the machine
used with a drive must generate a risk assessment for the machine and take appropriate
measures to ensure that unforeseen movements cannot cause personnel injury or property
damage.
Observe the chapters "Use as directed" and "Prohibited use" in the AKD Installation
l
Manual.
The PROFINET interface serves only for the connection of the AKD directly or via a
l
switch to a network with PROFINET connectivity.

3.4 Prohibited use

Other use than that described in chapter "Use as directed" is not intended and can lead to per-
sonnel injuries and equipment damage. The drive may not be used with a machine that does
not comply with appropriate national directives or standards. The use of the drive in the fol-
lowing environments is also prohibited:
potentially explosive areas
l
environments with corrosive and/or electrically conductive acids, alkaline solutions, oils,
l
vapors, dusts
ships or offshore applications
l
AKD PROFINET | 3 Safety
Kollmorgen | December 2014 11