King Industrial KC-6HJC Instruction Manual page 6

WARNING! TO REDUCE THE POTENTIAL FOR PERSONAL INJURY AND/OR
DAMAGE TO THE MACHINE, BEFORE ASSEMBLING MAKE SURE THE MA-
CHINE IS TURNED OFF AND THE PLUG IS NOT CONNECTED TO A POWER
SOURCE. DO NOT TURN ON OR PLUG IN THE MACHINE UNTIL INSTRUCTED
TO DO SO AFTER ALL ASSEMBLY STEPS IN THIS MANUAL HAVE BEEN COM-
PLETED.
Assembling the fence
1) Attach the fence support arm (A) Fig.4 to the rear of the cabinet (B) using 4 round
head allen screws (C).
2) Fit two round head allen screws through the holes in the fence mounting
bracket (A) Fig.5 and loosely thread a square nut (B) onto the end of each round
head allen screw.
3) Slide the t-slot in the rear of the fence (C) onto the square nuts (B).
4) Center the fence (C) on the mounting bracket (A) and secure it by tightening the
2 round head allen screws.
5) Sit the fence bracket (A) Fig.6 on the support arm (B). Slip the threaded end of
the fence lock handle (C), with flat washer (D), through the bracket and support
arm. Thread a square nut (E), flat end up, onto the threaded end of the lock han-
dle and tighten the lock handle to secure the fence assembly to the support arm.
Attach the dust chute
1) Loosen the four screws (A) Fig.7, position and secure the dust chute (B) to the
cabinet under the outfeed table as shown using the same four screws.
Note: The 2 1/2" dust port allows you to connect the machine to your shop dust
collection system (not included). Be sure to use correct size hoses and fittings (not
included). If you do not already own a dust collection system contact your King
Canada retailer or visit our website at www.kingcanada.com for information on our
complete line of dust collectors and accessories.
ASSEMBLY
FIGURE 4
FIGURE 5
FIGURE 6
FIGURE 7