Web User Interface; Operational Considerations - Tektronix SPG700 User Manual

Web user interface

Operational considerations

Levels of control
Supported Web browsers
SPG700 User Manual
When the Web user interface is enabled in the System menu, you can use a Web
browser to remotely control the instrument. Enter the IP address of the instrument
in a supported Web browser to open the SPG700 Web Interface. (See Figure 5.)
Click the various tabs to access the instrument settings and controls as you would
using the front panel buttons.
NOTE.
The Web user interface must be enabled from the System menu on the
instrument front-panel before it can be accessed from a Web browser. (See
page 109, System menu.)
It is recommended that a maximum of four simultaneous users be connected to the
instrument using the Web interface. If more users are connected, it may result in
lower performance and inconsistent behavior.
Some front panel operations may interrupt or reduce the performance of the Web
interface. For example, the Web server may experience temporary delays when
a large file is being transferred using the USB port or when many buttons are
being pressed on the front panel.
From the instrument front panel, use the Web User Interface setting in the System
menu to control the level of instrument access from a Web browser. Use the left
(◄) or right (►) arrow button to select between the following options. Press the
ENTER button to confirm the selection.
Full-Control. Allows a user to have full control of instrument settings when
using the Web User Interface.
Disable. Disables the instrument from being accessed by the Web User
Interface.
Read-Only. Allows a user to have read-only access to instrument settings
when using the Web User Interface.
NOTE.
Remote port 5000 is not required for the Web UI to function. If the SCPI
remote is not required it should be disabled to increase security and prevent
disruption by port scanners.
For best results, use Google Chrome, Mozilla Firefox, Safari, or Internet Explorer
9.0 or later when you connect to the SPG700 Web Interface.
NOTE.
The Web user interface requires Javascript to run.
7