Sdi Configure Zoneplate Submenu; Figure 16: Circle Zone Plate Configuration Parameters - Tektronix SPG700 User Manual

SDI menu (Option SDI only)
SDI Configure Zoneplate submenu
Zone plate parameters
settings
64
Use this submenu to configure the parameters of zone plate signals. These settings
become active when you select a zone plate signal for output from the Signal
Selection drop-down list. The information for each signal varies depending on the
individual zone plate signal.
The Configure Zoneplate submenu consists of three major sections: Zoneplate
Parameters, Video, and information that applies to all zone plate signals. For
more information on using zone plate signals, refer to the information later in this
document. (See page 95, SDI Zone plate signals.)
The following figure shows an example of the zone plate parameters for a circle
zone plate.
Figure 16: Circle zone plate configuration parameters
The information for the zone plate parameters varies with the zone plate signals.
The parameters are discussed in more detail later in this document.
Frequency. This menu item is dependent on the zone plate signal. Detailed
information for the different zone plate signals is provided in a separate table.
(See Table 26 on page 99.)
The remaining parameters are zone plate dependent parameters. These
are discussed in detail later in this document. (See page 100, Zone plate
dependent parameters.)
SPG700 User Manual