Remote Control; Web User Interface - Tektronix SPG8000A Installation And Safety Instructions

Table 10: Possible alert and fault error messages
Alert messages
Near loss of lock on REF input
Loss of lock on reference input
No GPS signal detected
VITC or LTC input missing
LTC out of SMPTE spec
No REF input signal detected
GPS Figure of Merit (FOM)
Alarm time

Remote control

Web user interface

When the Web user interface is enabled in the SYSTEM menu, you can use a Web browser to remotely access the instrument.
When you enter the IP address of the instrument in a supported Web browser, the Web Interface opens as shown in the following
figure. Click the various tabs to access the instrument settings and controls as you would using the front panel buttons.
Operational considerations. It is recommended that a maximum of four simultaneous users be connected to the instrument
using the Web interface. If more users are connected, it may result in lower performance and inconsistent behavior.
Some front panel operations may interrupt or reduce the performance of the Web interface. For example, the Web server may
experience temporary delays when a large file is being transferred using the USB port or when many buttons are being pressed
on the front panel.
Levels of control. Use the SYSTEM menu to control the level of instrument access from a Web browser. You can allow full
control or read-only access. When the Web user interface is disabled, no instrument access is allowed using a Web browser.
Supported Web browsers. For best results, use Google Chrome, Mozilla Firefox, Safari, or Internet Explorer 9.0 or later when
you connect to the Web Interface.
SPG8000A Installation and Safety Instructions
Fault messages
No fault
Main cooling fan fault
Temperature out of range
Internal diagnostic test failed
PS1 fault error
PS2 fault error
PS1 temp. wtd. hours exceed limit
PS2 temp. wtd. hours exceed limit
Controls and connections
25