Removing The Rear Access Panel; Drive Belt; To Remove Or Replace The Drive Belt; Removing The Large Pulley - Electrolux GOOD Service Manual

Removing the rear access panel:

1. Disconnect the washer from the electrical supply.
2. Remove the (6) screws holding the rear access
panel to the washer's rear panel and lift the access
panel off.

Drive belt:

The drive belt (6 rib flat Poly-V) is used to transmit power
from the motor pulley to the tub. The belt is constructed
of a material that stretches which makes belt tension
adjustments unnecessary.
Removing or replace the drive belt:
1. Disconnect the washer from the electrical supply and
remove the rear access panel.
2. Remove the belt by turning tub drive pulley and rolling
belt off pulley. The belt is elastic and is designed to
"give" enough to remove and install in this manner.

Removing the large pulley:

1. Disconnect the washer from the electrical supply.
2. Remove the rear access panel and the belt.
3. Using a #6 mm Allen wrench remove the bolt in the
center of the pulley by holding the pulley and turning
the bolt counter clockwise.
4. Work the pulley back and forth to remove it from the
shaft.
85