Table of Contents
Advertisement
10. Rear Panel Accessibility
Step: 1
Loosen the screws to remove the
Rear Access Panel (See Fig. 1).
From the Rear Panel we can
access:
1.
Belt
2. Heating Element Assembly
(Heater and NTC)
3. Motor Control Board
Assembly
4. Motor
10.1 Belt
Pull out Belt by
rotating pulley
in clockwise
direction (See
Fig. 1). Belt is
shown in figure.
10.2 Heating Element Assembly
(Heater and NTC) Accessibility
(Not applicable for 417 series)
Step: 1
Detach the
connectors of
Heater Assembly
(See Fig. 1),
loosen the nut
(See Fig. 2),
pull the heater
assembly from
the tub (See Fig.
3), and pull out
the NTC from the
heater assembly
(See
Fig. 4).
Heater
Assembly
is shown
in Fig. 5.
10.3 Motor Accessibility
Step: 1
Detach the
connector (See
Fig. 1), remove
the wire clip (See
Fig. 2), loosen
the bolts (See Fig. 3), and take out the Motor from the
machine as shown (See Fig. 4).
10.4 Motor Control Board
Assembly Accessibility
Step: 1
Loosen the screw from inside the Rear Panel (See
Fig.1), and the one from outside of the rear panel (See
Fig. 2). Release the snaps from the upper side (See
Fig. 3) and lower side (See Fig.4) of the Motor Control
Assembly for opening the Motor Control Board box.
Detach the connectors (See Fig. 5). Motor Control
Board Assembly is shown in figure.
26
Hide quick links:
Advertisement
Table of Contents
