Section H- Teardown; Removing The Detergent Drawer; Detergent Drawer Disassembly - Electrolux GOOD Service Manual

SECTION H- TEARDOWN

This section will describe how to remove components
from the 3.0 horizontal axis washer. Unless stated, the
procedure will be the same on all models. Unless stated,
reverse the procedure to reinstall the component.
Always remove electrical power from
the washer when working in an area where electrical
power is present.

Removing the detergent drawer:

1. Slide the safety latch lever to the right and pull the
drawer out until it hits the stop.
2. Push down on the release tab and pull the drawer
out.

Detergent drawer disassembly:

1. Remove the drawer from the washer.
2. The detergent, liquid bleach and fabric softener insert
lifts off. When reinstalling, be sure to seat it properly.
3. To remove the drawer front, release the three tabs
and pull the drawer front away from the body. When
replacing the drawer front always remember to
transfer the reed switch magnet.
4. To remove the conveyer release the conveyer from
the tabs and lift it off.
64