Table of Contents
Advertisement
Component Teardown
Power Cord Removal
The power cord is secured to the rear panel with a
strain relief.
To remove the power cord:
1. Remove the top panel.
2. Remove the ground clip from the upper rear
frame. (See Figure 4-42)
3. Disconnect the power cord from wire harness
at the Molex connector. (See Figure 4-42)
4. Using a pliers, compress the strain relief from
inside the unit compartment while pushing the
strain relief through the hole in the rear panel.
Pull power cord from unit. (See Figure 4-42)
Rear Access Cover Removal
The rear access cover mounts to the rear panel
and is secured with screws.
To remove the rear access cover:
1. Pull unit from its installation position.
2. Using a #2 square bit screwdriver, extract
the six screws securing rear access cover to
the rear panel. (See Figure 4-43)
Suspension Spring Removal
The suspension springs are located under a cover
bracket mounted on the top center brace.
To remove the suspension springs:
1. Remove the top panel.
2. Remove the overflow/vent tube.
3. Using a #2 square bit screwdriver, extract
the two screws from each cover bracket.
(See Figure 4-44)
4. Hook the top of the spring, and raise it about
1" to release the top hook from the center
brace flange, then allow it to drop about 6" to
relieve the spring pressure and then unhook
the other end of the spring from the tub.
NOTE: A strong rod at least 8" long with a hook
on one end and a handle on the other is needed.
Ground Clip
Strain Relief
Electrical Connection
Figure 4-42.
Figure 4-43.
Screws
Suspension
Spring
Figure 4-44.
4-16
Screws
Hide quick links:
Advertisement
Table of Contents
