Electrolux GOOD Service Manual page 53

The 2 outlets of the water inlet valve assembly are inserted
into the rear of the automatic dispenser. During the fill
cycles water is directed into the top of the cavity through
2 inlets. The inlet on the right, as view from the front of
the washer, is connected to the combination output of
the hot water solenoid and the center cold water solenoid.
The inlet on the left, as view from the front of the washer,
is connected left-hand cold water solenoid.
In the fill cycles, water enters into the top of cavity and is
directed across the top of the cavity by 4 channels: the
dispenser bypass channel, the detergent channel, bleach
channel and the fabric softener channel. The channel
that receives the water is determined by which inlet
supplies the water or if both inlets supply the water.
The dispenser advanced rinsing technology channel
receives water whenever the inlet on the right, as viewed
from the front of the washer, is activated.
This path allows the water to bypass the dispenser drawer
and enter the tub by an advanced rinsing technology
hose connected between the cavity and the bellows.
The detergent dispenser channel receives water from the
right-hand input, as viewed from the front of the washer.
The detergent channel forms a loop, that allows the water
to pass over the detergent section of the drawer.
53