To Remove The Air Bell; Removing The Tub Assembly - Electrolux GOOD Service Manual

4. Remove air shock securement pins by depressing
locking tab while pulling pin to remove.
This procedure is much easier if a deep 1/2", 6 point
socket (or 13 millimeter, 6 point) is used to
compress the locking tab of the plastic pin. Push the
socket onto the tapered end of the pin as far as it will
go to compress the locking tab.
5. Use pliers to grasp head of pin and pull to remove.
As the pin is removed the socket will drop free.
6. When replacing the air shock make sure to position
it with the bell end facing downward.
7. Lubricate the securement pins with Sil-Glide®
before installing.
Removing the air bell:
1. Disconnect the washer from the electrical supply
and remove the front access panel.
2. Remove the (2) hoses, one from each end.
3. Release the rivet holding the air bell to the outer tub.
NOTE: Seal air connecting tube to air bell and air
bell to sump hose using waterproof glue.
DO NOT plug air connecting tube opening.

Removing the tub assembly:

1. Disconnect the washer from the electrical supply
and the hot and cold water hoses.
2. Remove the top panel, console, front and rear
access panels and the front panel.
3. Disconnect the advance rinsing technology hose
from the bellows, the detergent outlet and siphon
break hoses from the outer tub.
4. Remove the drain pump and disconnect the drain
sump from the tub.
89